8.4" to 12.1" screen replacement

[Emarkowski24]

Yup paired

 

[Emarkowski24]

So I got it connected now but it shows it’s connected but won’t bring up any options

 

[Bram2019]

Click on regular mode

 

[Bram2019]

Then active diagnostic

 

[Bram2019]

Then open the big pull down window. Then choose car configuration change. Then select option open that window

 

[Emarkowski24]

Almost there the only thing is not allowing me to do is hit start after I disable the one and enable the other

 

[Bram2019]

Did you disable the integrated center stack

 

[Jimmy07]

So I got it connected now but it shows it’s connected but won’t bring up any options

Change the interface back to OBD Link BT

 

[Jimmy07]

Almost there the only thing is not allowing me to do is hit start after I disable the one and enable the other

Status:idle= not connected

 

[Emarkowski24]

Connected and disabled and enabled still nothing

 

[Jimmy07]

Connected and disabled and enabled still nothing

Leave the settings as is. Try a few drive cycles.

 

[Emarkowski24]

Engine on and off 5 times still nothing

 

[Jimmy07]

Engine on and off 5 times still nothing

In AlfaOBD, switch to advanced mode. For “device” select display screen module powernet. For “modification” select RU Pacifica. Click connect. Does it connect, or does it go through three CAN attempts and fail?

 

[Emarkowski24]

Idk what the hell happened but woot wooo thank you guys we are all good now just gotta figure out how to get this off

 

[Emarkowski24]

www.ivgsoft.com

If I go to here for the code but they don’t have dodge or ram as an option? Any ideas

 

[Jimmy07]

www.ivgsoft.com

If I go to here for the code but they don’t have dodge or ram as an option? Any ideas

Select these values, then whatever part number your radio module is-

 

[Emarkowski24]

May be a stupid question but how do I find part number?

 

[Emarkowski24]

And wouldn’t it be the 12 inch? UJX?

 

[Emarkowski24]

The module is UCX Canadian

 

[Jimmy07]

May be a stupid question but how do I find part number?

In AlfaOBD, instead of selecting body computer to connect to, select radio navigator module 2017. Connect to it, and select the faults and status log tab. Select read system ID, and that will reveal the radio module part number.
Trust me, you’ll choose the 8.4 UAX selection pictured.