Recent content by Dougs 2021 Ram

I used these https://www.ebay.com/itm/274126246696?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=leCytslIR9u&sssrc=2047675&ssuid=S8MM__-UQhm&widget_ver=artemis&media=COPY

i had lost one when i did my brake controller also , and like a week later a broke rear door scuff plate which had same clips that i linked to earlier so i used one of those off the broken scuff plate for the knee bolster after i ordered new plate

this is another view of that part

is this it https://store.mopar.com/oem-parts/mopar-clip-cluster-bezel-to-i-p-6510407ab?c=Zz1mcmFtZS1idW1wZXItYW5kLWZhc2NpYSZzPWZyb250LWJ1bXBlci1hbmQtZmFzY2lhJmw9NyZuPVNlYXJjaCBSZXN1bHRzJmE9cmFtJm89MTUwMCZ5PTIwMjEmdD1iaWctaG9ybiZlPTUtN2wtdjgtZ2Fz

Good morning I was going to do the led headlight swap today with jimmy07 harness at my workplace, however I forgot my obd adapter n gateway bypass at home. Would there be any risk or concerns if I do the swap and then reprogram when I get home Thanks I'm advance

this is front fascia connector plugs and pin , these are for a 2021 i am not sure if they changed for 2022

Look through this thread a lot of information Trailer Tire Pressure Monitoring System

I have felt the same thing . i Chalked it up to Ready Alert Braking (RAB) RAB may reduce the time required to reach full braking during emergency braking situations. It anticipates when an emergency braking situation may occur by monitoring how fast the throttle is released by the driver. The...

I tied them into the puddle lights on my mirrors using this relay https://www.amazon.com/dp/B09T3RT5MG?psc=1&ref_=cm_sw_r_cp_ud_ct_5E39XGC1FKPHRCBCXGVK . this relay closes the switch at @ 3 volts as the puddle lights ramp up from 0 to 12 volts upon activation i spliced the wires from the...

i wanted a matte to satin finish on my handles, the black diamond crystal has a glossy finish with a metal flake in it .So I used this on my handles . its sort of a satin Black, Trim Black Ultra | 49143 | SEM Products I used a wax and grease remover , scuff with a grey scuff pad , degreased...

https://www.littleshopmfg.com/ram-5-7-belt-driven-compressor-kit/

i did mine this way . this guys did a nice video

This page is very helpful for connectors and pinouts http://connectors.dcctools.com/home.htm

https://www.instagram.com/tv/Ch3PS-Ist7q/?utm_source=ig_web_copy_link