Search results

I had an issue with my '19. The sunroof motors sounded like they were going to burn out because they were working so hard to open and close the panel ( vent was fine). it also took a while to either open or close and I couldn't close it when the truck was moving because the anti pinch would...

Add me to the cracked/leaking rear window club. So far ive tried 2 layers of flowable silicone over the whole seam where the window meets the cab, also sealing the cracks in the frame and anywhere else I can see where water could enter. Ive slowed it down, but not stopped it. Next course of...

Truck went in today for the exhaust leak, 2 broken studs fixed and a manifold later its done. They said the other side still looked good

Im thinking if mine crack after warranty, this is the route im gonna go.

Mine is going in April 10 to have the passenger side fixed. I only have ticking for 45 seconds or so on cold startup. im within the 5/100 warranty so it'll be free and the dealer said they'd check the other side while they are at it. my truck is a '19 with 75,000kms on it. I checked it the...

I replaced my door speakers and tweeters with the Mopar kicker upgrade. No complaints as of yet. I have the Alpine system

Same thing happened to my '19, unplugged the air dam under the bumper and all is well. Ram did extend the warranty on these parts for 8 years / unlimited mileage though

Got mine figured out, turns out my $40 scanner wasn't reading the correct code. It was actually u11E9 which is the active grill shutters. The grill shutters and the active air dam ( if equipped ) are on the same circuit and PCM signal. Apparently the air dam motor is known for getting water...

Thanks for the offer, but im in Canada so unless something has changed, you won't be able to assist

Mine did this twice today, remote start, ran 10-15 seconds truck shuts down. Checked the code U1109 is what came up on mine. Seems to be a fairly random code that gets generated by whatever is causing this

Its in the computer. Canadian trucks have the low beams on as a DRL which cannot be switched off via the switch ( Canadian traffic laws ) My 19 is the same way ( Im in Canada ). There are light modules that will allow you to turn them off / change what lights up available though.

Just about 2 years old.

I just had to replace both of my 1000HD bags, one had a small tear and the other the bottom was torn severely . I believe the one with the torn bottom was caused by towing a camper without air in the system ( bag with small tear ). Airlift replaced them and good to go now! I put my fill valve...

The wire connections to the glass on these trucks is garbage! Ive had to fix mine twice already, and noticed the other morning the pass side of the rear glass is not defrosting, so ill have to take the rear seat out again and fix it. Basically there's little " buttons " that are attached to the...

So as an update to my sunroof issues, turns out the entire track was bent. Dealer installed a new track assembly and 2 new motors , sunroof now works great!!

The switch that's on them isn't an on / off switch, its more of a momentary switch if I remember correct. I don't use it.

They come with about 6" of wire that plugs into he light, the other end also has a plug that would plug into the factory harness of the truck if it was equipped from the factory

I had a cheapie lighter on my 4th gen sport, although it was very bright and worked great ( no leds burnt out ). I did notice though over a year or two the lens yellowed quite a bit from the sunlight ( think of the yellow film left on windows from smoking ). It wasn't terribly noticeable...

Some have carbon, the 1st 5th gen I drove was a limited with carbon wheel / interior trim. Either way my parts girl said shed love to do the upgrade for me, but being a warranty issue theres no way to make it work via the FCA system so no upgrade for me

Mines discolouring as well. Dealer is replacing it for me, but the wheels are on backorder. I should see if I can manage an upgrade to the limited wheel with carbon fibre at the top.... hmm