What did you do to your Ram today???

[Scram1500]

Here is how it looks with DRL set to turn signals:

View attachment 188720

Looks good, how did you get that to work?

Reason I ask, slightly on topic, I have my XB signature lights wired to switch and when they're off the turn signal will hyperflash after a few seconds and stop working completely. Wonder if you can just have the amber without the white. I came from halogen though an it looks like you started with LED

 

[billfraley]

You like these over the stock led setup?

Far better than the reflector LEDs, but the Limited/Longhorn are still better than these. I previously owned a '20 Longhorn, so I have used both. My original plan was to do a Limited/Longhorn front end swap, but the deal on these lights was too good to pass up. These are a good alternative at the right price.

 

[billfraley]

Looks good, how did you get that to work?

Reason I ask, slightly on topic, I have my XB signature lights wired to switch and when they're off the turn signal will hyperflash after a few seconds and stop working completely. Wonder if you can just have the amber without the white. I came from halogen though an it looks like you started with LED

Well, I had LEDs from the factory. So I did not have to wire anything extra. However, I am sure there is a way to get them working properly. I had a 22 Jeep Gladiator and I added some aftermarket headlights with signature lighting. I was able to determine the signature lighting circuit in the harness and wired them just like OEM. Then I just had to enable the feature in the BCM. If we know the connector number we could easily look this up.

I am an engineer as my occupation, so I am used to reverse engineering to solve problems.

 

[billfraley]

Looks good, how did you get that to work?

Reason I ask, slightly on topic, I have my XB signature lights wired to switch and when they're off the turn signal will hyperflash after a few seconds and stop working completely. Wonder if you can just have the amber without the white. I came from halogen though an it looks like you started with LED

Also, I bet if you disable the debugging setting for the turn signals, or set them to LED, it would stop them from getting disabled.