5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Mopar’s “Ram Airflow” Cold-Air Intake System For Ram 1500:

I need "snap in clips" #8 below, Does anyone know where I can get them, what's the part number?
Or anything as an alternative?

1743115068790.png
 
Gskowronek, man I wish I had a good answer for as I needed them too when I bought a used set up. I ended up using a similar fastener as the picture shows. I bought a box of Auveco 22909 from Amazon. Problem was they are not quite big enough for my 2022. I was able to bend them some to make them work. I did break a couple trying to “enlarge” them. In the end they worked but as I said, not really right.
 
Gskowronek, man I wish I had a good answer for as I needed them too when I bought a used set up. I ended up using a similar fastener as the picture shows. I bought a box of Auveco 22909 from Amazon. Problem was they are not quite big enough for my 2022. I was able to bend them some to make them work. I did break a couple trying to “enlarge” them. In the end they worked but as I said, not really right.
I ordered the same ones, nothing else available, will update when they arrive
 
Yea kinda sucks you can’t get the right ones, I mean obviously someone manufactures them. You get like 20 or 25 clips, just tweak them enough to stay in place. If you break one no biggie. You have backup!!!
 
Can someone please post nice quality photos of these clips? from different angles?
 
If I remember right I think my mounting hole was rectangular. The Auveco # crosses over to the Chrysler part number. OP, if your hole is square these will pop right in. No tweaking necessary, but in my case, I had to bend them. Is your hole square?
 
If I remember right I think my mounting hole was rectangular. The Auveco # crosses over to the Chrysler part number. OP, if your hole is square these will pop right in. No tweaking necessary, but in my case, I had to bend them. Is your hole square?
Rectangular, here is from my 2024 :

1743428616122.png

1743428683846.png
 
Yup. Same as mine. So I slowly bent the clips outwards so they would catch under the edge on the longer sides.
 

Users who are viewing this thread

Back
Top