the buttons areCross Referenced.
I find post #3 interesting, add a couple of buttons and new cover to upgrade the your remote functions.
How difficult is it to solder in those buttons? What tools and skill level?
New cover for the remote is not that difficult and my replacement cost less than $14.
The points are on the BH remote all you have to do is solder the momentary switches in place, here a pic of the board
T/g tailgate, r/s remote start.
These switch will work I'll be soldiering in the 3x3.5x2 tomorrow
Amazon.com
Also order this case
Keyecu Replacement Remote Car Key... Amazon.com
Here's a prospective on how smalls the buttons are. They measure 3mm x 3mm or 1/8 x 1/8. For me it's fairly easy to solider them, I use to fix circuit board traces. Not for the average user, as the point are smaller then most over the counter iron tips.Cross Referenced.
I find post #3 interesting, add a couple of buttons and new cover to upgrade the your remote functions.
How difficult is it to solder in those buttons? What tools and skill level?
New cover for the remote is not that difficult and my replacement cost less than $14.
The points are on the BH remote all you have to do is solder the momentary switches in place, here a pic of the board
T/g tailgate, r/s remote start.
These switch will work I'll be soldiering in the 3x3.5x2 tomorrow
Amazon.com
Also order this case
Keyecu Replacement Remote Car Key... Amazon.com
I soldiered the buttons on my remote and the remote start nor tailgate light didn't flash when I pushed them. iall other buttons still work fine.
i also but a button on the center location of another remote that i have for the truck with 4 button remotes, with same results.
Don't have tools to connect to truck yet, so I don't have remote start turned on yet. just doing what I can as I can. I also have new fobs on the way to compare.
