5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

2.5" Motofab lift with 35" ridge grapplers

PorBoy

Spends too much time on here
Joined
Jun 15, 2018
Messages
4,554
Reaction score
2,692
Location
Millville NJ
I see that one of your “ past “ mods was a Pulsar, may I ask what happened there ?
 

stax199

Active Member
Joined
Aug 31, 2019
Messages
76
Reaction score
89
The shop me not to worry about the uca's because the angle isn't even bad.
thanks.. i was hoping I could just install these in my non ORG non air suspension without replacing UCA's.
 

rob989_69

Active Member
Joined
Aug 21, 2019
Messages
79
Reaction score
43
Do you know, is there any clearance difference for 4wd? Love to run 35x11.5 or 12.5 if possible on stock 20's. Hard to find confirmation around here.
 

stax199

Active Member
Joined
Aug 31, 2019
Messages
76
Reaction score
89
Yeah just check the angle of the ball joint cause you never know yours might not be okay.
thanks again.. so inspect the ball joint after install.. then decide to add new aftermarket UCA?
 

Users who are viewing this thread

Top