motofab

registered my vehicle on mopar and looked into specs. I did not see anything about air ride. I have purchased 3”front and 2”back motofab pucks for leveling my rebel. I also have purchased the rough country 3”-3.5” UCA’s. Am i going to run into issues during installation? Im seeing half and half...

From what I have gathered from reading different posts if I put the 2” top hats on With my ORG that should be the same as a non-ORG with a 3” level, am I a correct about that? And now being at 3” is it a must that I install new UCA’s? I’m hoping to run a 22” x 12” wheel with a -51 offset, tires...

I’m currently running part of the 3.5” Readylift on my ram rebel - has the top strut spacer, rear spacers, and upper control arms. took off the preloaded spacer, to get the smooth ride back - Would you guys recommend the 2.5” motofab spacer or 3” spacer, to get rid of the non leveled looK...

Just installed wheels and tires a couple days ago. Ordered off Custom Offsets. They messed up first order a month ago (never shipped) but made second order right and wheels/tires showed up in a week. Weights used for balance suck but balance is good up to about 75mph and then there's noticeable...

I purchased the ReadyLift 67-1500 UCA’s to go with the MotoFab 2.5” Leveling Kit and just wanted to make sure these UCA’s will fit on the 5th gens. I’ve seen people say they fit fine even though they’re meant for the 4th Gens but just wanted to verify.

I have some extra parts I’m willing to give away for free if someone wants to come pick them up in Redmond, WA. They are 2 brand new/ unused front strut spacers (1/2”) made by Motofab for 2019+ Rams. Installing will result in 1” of front lift with minimal affect to ride quality. Hit me up if you...

Before and after pics. Ram 1500 2wd bighorn 2.5" motofab lift with 35/11.50 ridge grapplers on 20" Laramie wheels.