2” Rough Country front leveling strut kit

[b.w.royder]

I had

I’m taking mine back to the shop tomorrow and let them figure out what they did wrong. If they can’t, I’ll have them uninstall and go back to factory until I can get a clear idea of what’s what. Frustrating!

I had to do the same. I had the 2 in puck from ready lift. So much noise. Couldn’t take it.

 

[mike_ct]

Having the alignment done tomorrow. Something to consider... If you are looking to gain 1" the top of strut spacer out of the Traxda kit would you give you very close to that for less $$ or a spacer similar to it. I am going to guess the RC struts provide the same ride quality as the rebel struts. Also in you case I would also think the change in alignment would be minimal.

Had truck aligned the camber was off just a small amount. $100 from the dealerships.

Hey man been a few months. How’s the shocks doing?

 

[Beauloafer]

Hey man been a few months. How’s the shocks doing?

No issues. I think it was a good choice. I will be adding 1" spacer to the rear coils for pulling the camper.

 

[Billetram1500]

Just did mine and I love it 39 1/8 front and 38 3/4 rear to the bottom side of the fender

Sent from my iPhone using Tapatalk

 

[Billetram1500]

Sent from my iPhone using Tapatalk

 

[agjr85]

Sent from my iPhone using Tapatalk

Feedback on the ride. May need to throw some miles on them. Initial drive impressions?

 

[Billetram1500]

Feedback on the ride. May need to throw some miles on them. Initial drive impressions?

Rides nice! Took it down a road around called rally road and they felt great! Hopfully they last.


Sent from my iPhone using Tapatalk

 

[agjr85]

Found them on sale on JeepHut.com for $300 w/ no tax and free shipping.
Hopefully, they arrive before Friday and I can possibly get them on over the holiday.

 

[agjr85]

Sent from my iPhone using Tapatalk

Did yours come with instructions for the 4th gen?
The part # on the box doesn't match the one on the site. I need to look at what is stamped on it.
Just got mine yesterday.

 

[Billetram1500]

Did yours come with instructions for the 4th gen?
The part # on the box doesn't match the one on the site. I need to look at what is stamped on it.
Just got mine yesterday.

I ordered the ones labeled 2019 2” leveling strut. Not sure what the instructions said


Sent from my iPhone using Tapatalk

 

[NanoBru]

Rides nice! Took it down a road around called rally road and they felt great! Hopfully they last.


Sent from my iPhone using Tapatalk

So we're a month out and how are they now? I'm considering these right now and this thread has been helpful. Wondering if any change in ride quality? Noise?

 

[Billetram1500]

So we're a month out and how are they now? I'm considering these right now and this thread has been helpful. Wondering if any change in ride quality? Noise?

Still seem to be holding up great rides great no noise. So far they have been worth it.


Sent from my iPhone using Tapatalk

 

[jfizzlewhaaat]

Still seem to be holding up great rides great no noise. So far they have been worth it.


Sent from my iPhone using Tapatalk

I have these sitting in my garage waiting for install. I also ordered the rear shocks to replace OEM. On top of that i have some inside coil bags for the rear.
I’ve been torn on the RC after all the negative that I’ve read and watched about them. This has helped a bunch though. Can’t wait to get them installed. I have a 2010 Ram 1500 so i got the 2.5 inch strut.

 

[CRAIG4FSU]

I just had the 2" strut installed on the front of my 2021 1500 2WD. It went from about 2 3/4" low in the front to 3/4" high in the front. The shop that installed them said they will "settle" with in a couple of weeks.

Are you guys familiar with "settling"?

 

[doolin64]

They will settle. My RC 3.5" struts. Settled a little over .5". I was measured 4" of lift after installed. Not it's just below 3.5" and looks great.