Ultimate OBD JScan Thread

[Brutal_HO]

Don’t know about that, but support at JScan is very helpful. I emailed them yesterday about turning on trailer light check and got a response from them this morning. Their support put me in the right direction and now trailer light check works.

So when are you going to post up that procedure?

 

[Retired Old Fart from TN]

So when are you going to post up that procedure?

Figured thread was dead or nobody interested since I didn’t get any response to my question, but here you go
In JScan,
Body -> Configure

Trailer Light Check Present
Change to Set

Trailer Light Check Cycles
Set to amount of times you want to cycle through lights.

 

[theblet]

Figured thread was dead or nobody interested since I didn’t get any response to my question, but here you go
In JScan,
Body -> Configure

Trailer Light Check Present
Change to Set

Trailer Light Check Cycles
Set to amount of times you want to cycle through lights.

It’s not dead. I think we have just done through the most common and useful changes already. Thanks for posting this. Very helpful! When does the check run or do you have to initiate it somehow?

 

[Retired Old Fart from TN]

It’s not dead. I think we have just done through the most common and useful changes already. Thanks for posting this. Very helpful! When does the check run or do you have to initiate it somehow?

In the trailer to section on dash display not on radio. After you set it up through JScan it will show up but give you some kind of error if you are not connected to trailer.