So last week I had some Kavaca PPF installed on my truck and while it looked ok from a distance, there's a number of bubbles and areas where the film is not sticking and is pulling up. I mentioned it while I picked the truck up and was told to keep an eye on the areas and try to work them back down and they will even out over time. Also, I am supposed to bring my truck back for a wash/follow-up so that they can remedy the minor inconsistencies that were observed upon pick-up. I think I'm going to be complaining about more than they are going to expect because I think some of the film needs be re-cut, maybe reapplied to fully fix the issues.
For those of you who have had this or a similar film applied, did you experience anything similar to this with the PPF/install? The area that I had covered (see red lines below) is somewhat tedious with plenty of curves, but at nearly $1,000 to have the job done, I expect it to be perfect.
For those of you who have had this or a similar film applied, did you experience anything similar to this with the PPF/install? The area that I had covered (see red lines below) is somewhat tedious with plenty of curves, but at nearly $1,000 to have the job done, I expect it to be perfect.
