5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Is it possible to add Blind Spot?

Hi, just read through most of this forum. I have no problem doing the install and running wires from tail lights to can bus. Just installed and programmed a 7" cluster with AlfaOBD, so I am familiar with programming. I saw @Jimmy07 may have the necessary wiring to purchase? I am going to purchase factory OEM tailights and the modules separate, but I am not experienced enough to do any splicing or modifying connectors. If anyone has the wiring that works similar to the infotainment set up or can customize this, I am willing to pay. Any help is appreciated.
 
Just finished updating my 2019 BigHorn Gen 5 with the BSM. I purchased OEM tail lights thru ebay and new mirrors with BSM, heated dimmer on mopar. Jimmy07 provided XY400 wiring (thanks!) and the document to install is spot on (getting the plugs out on the XY is hard and take your time). The biggest problem I had was the right BSM not recognized as I bought 68489300AA wire harness and a depinned on driver side. However, I had orginal 68357200 / 220 AD harness and connected the BSM tail lights to it and worked great. The BSM module is 68263397AD. I wondering if the 300AA work with a newer BSM module and not with the older? This was my first time doing anything like this and wasn't too bad except for the cable issue I had. Great thanks on this forum as a lot of info here and save a ton of $.
 
Just finished updating my 2019 BigHorn Gen 5 with the BSM. I purchased OEM tail lights thru ebay and new mirrors with BSM, heated dimmer on mopar. Jimmy07 provided XY400 wiring (thanks!) and the document to install is spot on (getting the plugs out on the XY is hard and take your time). The biggest problem I had was the right BSM not recognized as I bought 68489300AA wire harness and a depinned on driver side. However, I had orginal 68357200 / 220 AD harness and connected the BSM tail lights to it and worked great. The BSM module is 68263397AD. I wondering if the 300AA work with a newer BSM module and not with the older? This was my first time doing anything like this and wasn't too bad except for the cable issue I had. Great thanks on this forum as a lot of info here and save a ton of $.
I also have a 2019 bighorn and am doing the conversion/ add on. I already purchased the mirrors with blind spot monitoring lights but I see that you said you purchased 68263397AD modules. Do both modules need to be that same part number? I saw on the write up that 68263397AC was required. Others used different part number sensors as well. That's the only thing that has me confused. Any assistance? Thanks in advance.
 
The current model BSM ends in AE which replaced AD and AC. So I don't know if you can mix and match. My only thought was the cable ending in 300AA didn't seem to recognize the right BSM but I used my original cables ending in 200/220 and that worked.
 
The current model BSM ends in AE which replaced AD and AC. So I don't know if you can mix and match. My only thought was the cable ending in 300AA didn't seem to recognize the right BSM but I used my original cables ending in 200/220 and that worked.
Thanks for the help and input. 👍
 

Users who are viewing this thread

Back
Top