BIGHORN gets Bilstein 5100’s

[jl13]

Not too many at moment but here's a cpl.

what size tires are running

 

[deanno33]

what size tires are running

275 60 20 (33"). Stock was 32" so just went up 1"

 

[jl13]

275 60 20 (33"). Stock was 32" so just went up 1"

thanks, great looking truck

 

[Sugar]

I have a 21 Laramie 1500 non ORP 4wd.

I believe I am going with Bilstein 5100's up front and Icon 1.5 springs in the back. Anyone running this? or think its a problem?

I should sit like a leveled ORP at the end.

I’m running this but also with a spacer up front. Very happy with the ride. Little rougher at times but it feels good. Also had a Laramie nonorp. Only complaint I have is I get some spring slap from the icon springs. If I knew this I would have gotten some coil sleeves and installed while putting them on.

 

[Mbrigh3]

I’m running this but also with a spacer up front. Very happy with the ride. Little rougher at times but it feels good. Also had a Laramie nonorp. Only complaint I have is I get some spring slap from the icon springs. If I knew this I would have gotten some coil sleeves and installed while putting them on.

did you need the front spacer? to much rake? pics of it without the additional front spacer.

I am going 1" or 1.5" spacer in the rear with 2 inch Bilstein's up front. I wont be changing the rear springs.

 

[Sugar]

did you need the front spacer? to much rake? pics of it without the additional front spacer.

I am going 1" or 1.5" spacer in the rear with 2 inch Bilstein's up front. I wont be changing the rear springs.

I had purchased the 2” readylift kit with UCAs to use. I essentially was looking to do a 3.5 lift using that kit and bilstein 5100s in front and adding 5100s and icon springs in the rear. I have about 1/2” rake currently. If the truck is sitting the right way it looks slightly nose high at times. I will eventually change out the rear to Clayton 2.5” rear springs instead. I went this route because I like the look more and wanted to run 35” tires. Tires fit well with this setup currently. I also wanted the springs to reduce the sag of the soft factory springs when loaded. The non orp truck did not handle a ton of gravel well

I don’t have any pictures without the spacer in the front. If you look at the fox 2” thread or the bilstein 5100 thread you can find some people who are running similar to you.

Updated 2" Mopar Lift/Level Kit - Discussion

Hello All, Wanted to create a thread for pictures/discussions about the updated Mopar Lift/Level Kit (Part#: 77072424AB) - available early May for the public. I luckily was one of the first to receive and can verify that it does sit closer to level than the original Mopar-Fox 2" Lift kits...

5thgenrams.com

Bilstein 5100

Apologies if this has been asked before, but I havent found a solid answer yet. Has anyone found a part # for the 2019 rams yet? Or been given conframation that the 2018 will work on 2019? I currently have preload installed. And I feel these would be best for what I want to achieve. Thanks...

5thgenrams.com

I also have 1” and 1.5” rear spacers I’d be willing to sell if you are still looking for some.