Doesn’t interfere or use the backup camera wiring at all. The clips mount on the same parallel as the plastic cover for the backup camera wiring but I used some 1/4 plastic spacers in the outside clips and 1/2 inch plastic spacers on the inside two and it will just sit in front of the plastic cap. (Had them lying around from some TV wall mount kits)
For the actual wiring you use a Curt 56584 (Link Below) and it is just a splitter for behind where your trailer wiring connector is that adds another 5 pin connector that you use. I then cut the bullet plug off of the included “hard wire” plug and used that in the extra hole for the reverse light.
The hardest part was finding the correct spacer size so the tailgate didn’t hit it and finding out that to remove the existing connector to plug in the Curt adapter you have to pry the tab up and not push down. It was on the top so I couldn’t see it and I was trying to push down for a long time before I just took a picture with my phone and could see it.
All you need is what’s included with the bar, the curt connector, 2 1/4 inch and 2 1/2 inch spacers and used some zip ties and electrical tape to tuck everything back up.
Curt Manufacturing 56584 Trailer Connector
https://www.amazon.com/dp/B007EA6WQU/ref=cm_sw_r_cp_api_i_Om2oCb2A6CN1Z
Sent from my iPhone using Tapatalk