Rambox wiring to main harness

[dforaker79]

Troubleshooting a nagging annoyance on my drivers side Rambox. The unlock button has never worked. It was not the lid or actuator because I took the lid off and plugged it into the other side and it works. So, I started looking at the wiring and found the main connector below the Rambox completely full of dirt and corroded so bad, I cannot even disconnect it from the Rambox. I even found one of the wires burned, falling out of the connector, and the wire next to it has insulation missing. I already ordered a new jumper harness and replacement jumpers for the Rambox. My question is, the passenger side has a shield to protect these connectors, it seems I may be missing it on the drivers side. Can anyone with Ramboxes verify there is a shield there underneath where the Rambox connects?

 

[Aidan]

Sorry, I don't have the answer to your question, I'm replacing my truck bed (non ram box) with a ram box bed and am struggling to identify the part numbers - I need the jumper wiring (and harness maybe?) so was wondering if you please share the part numbers you used?

 

[dforaker79]

Sorry, I don't have the answer to your question, I'm replacing my truck bed (non ram box) with a ram box bed and am struggling to identify the part numbers - I need the jumper wiring (and harness maybe?) so was wondering if you please share the part numbers you used?

I bought the left side jumper.

 

[Aidan]

Amazing, thank you.