The pictures are of the LED light connection I made to the footwell lights - I connected both passenger and driver side together and ran 1 wire to the footwell light and tapped into the wire from the connector. There are three wires associated with the connector a Black wire, Yellow wire w/purple stripe and a Yellow w/green stripe wire. The black wire is the ground wire and the Yellow w/purple stripe is the Dome/door assist lighting. this is the wire to connect if you want the lights to come on any time you unlock your truck or open any door and will fade out with the dome light. The yellow w/green stripe goes to the ambient lighting system - this wire will come on and stay on during night time only due to the sensor. My light LED kit also connected to the park and turn signal lights and will sequential with the turn signals. for the wiring of that option I used by 4-pin tow connector at the back of the truck and ran the wires to the front of the truck where I connected both driver and passenger LED lights in parallel, except the left and right turn signal was connected as a single connection. I hope this helps. By using the park light wire on the 4-pin connector the yellow running LED
strip light does not come on until night or rain basically anytime your regular lights come on and not your running lights.
View attachment 57006View attachment 57008View attachment 57009View attachment 57010View attachment 57011View attachment 57012 The 4-pin tow plug I purchased was a extension plug that you would wire up for a trailer and connected to my LED light strip creating its own plug.
