I forgot to add that on my way to work I bumped a Deer. I come
around the corner and four Deer were having a meeting in my lane.
I hit the brakes and swerved to the on coming lanes. The deer then
bolted across that lane and I just bumped the last one. Probably
knocked it off its feet as it took a little time to catch up to the rest.
Picked up the new Scan tool, removed the Pedal Commander, reset
the codes I could. Only the CEL remains lit because of the Permanent codes.
The truck it driv\able again. Hopefully the CEL will reset itself soon. I have to
get the truck inspected this month and it will not pass with the CEL on.
Cross your Fingers, Eyes, Arms, and Legs.
Malodave
You need to do a trip cycle. Then it should become a history code and you can clear it.
This is the only doc I can find for a 2019.
All Monitor Drive Trace
Do not turn off until all steps are complete or you have to restart.
Check fuel level >1/4 and not Full.
Start engine, Idle for 5 minutes
Warm engine up for five minutes ( >160F coolant temp for 5 minutes can be met while driving )
Smoothly acceerate and maintain a speed between 40 to 60 mph for 8-10 minutes.
Stop and idle for 3 minutes.
Smoothly accelerate and maintain a speed above 20 mph for 2 minutes.
Turn key off, leave off for ten minutes
This should set all monitors below.
Catalyst Monitor Drive Trace
Idle for 5 minutes
Smoothly accelerate and maintain a speed between 30 to 45 mph for 2 minutes.
EGR System Monitor Drive Trace – Vacuum controlled
Idle for 5 minutes
Smoothly accelerate and maintain a speed between 40 to 60 mph for 2 minutes.
EGR System Monitor Drive Trace – Electronic
Idle for 5 minutes
Smoothly accelerate and maintain a speed between 40 to 60 mph for 2 minutes.
Idle for 3 minutes
Evaporative System Monitor Drive Trace
Trace 1: Standard Type – Make sure that your fuel level is between 50% and 85% full.
Idle for 5 minutes
Smoothly accelerate and maintain a speed between 30 to 45 mph for 2 minutes.
Trace 2: Leak Detection Pump
From 6-8 hours of the vehicle being off (cold soak), idle for 5 minutes
Drive in city traffic naturally with stops and acceleration for 5 minutes.
Stop. Idle vehicle for 4 minutes.
O2 Sensor Monitor Drive Trace
Idle for 5 minutes
Smoothly accelerate and maintain a speed above 25 mph for 2 minutes.
Stop and idle for 30 seconds.
Smoothly accelerate and maintain a speed between 30 to 40 mph
Repeat idle and acceleration to 30-40 mph five times.
O2 Sensor Heater Monitor Drive Trace
Idle for 5 minutes, then shut the engine and leave the vehicle off for 10 minutes.