moosem
Ram Guru
I recently purchaesed and installed Morimoto XB LED Fog Lights (Type S), and noticed that they are flickering slightly when the engine is running at idle. They do not flicker at all with the engine off and they also appear to not be flickering if I rev the engine to 2000 RPM.
It is not very noticeable when looking at the lights themselves, but it is noticeable when looking at the light pattern cast onto my garage door at night.
I contacted the seller and confirmed that they do not require an anti-flickering module.
I checked the negative battery terminal to make sure it wasn't loose. It was only slightly loose, so I tightened it but the flickering did not go away.
I also checked the other ground points in the engine bay and those were all tight. I don't know if I got them all. I saw three on the driver side there may be more. I don't know.
I double checked the wiring polarity at the fog light connectors and those are correct per the install video from Headlight Revolution.
I verified that the battery voltage is maintaining a steady 14.5V at idle.
I'm not sure what else to check.
Has anybody else experienced anything similar?
Any advice as to how I should troubleshoot this?
Thanks in advance for your help!
It is not very noticeable when looking at the lights themselves, but it is noticeable when looking at the light pattern cast onto my garage door at night.
I contacted the seller and confirmed that they do not require an anti-flickering module.
I checked the negative battery terminal to make sure it wasn't loose. It was only slightly loose, so I tightened it but the flickering did not go away.
I also checked the other ground points in the engine bay and those were all tight. I don't know if I got them all. I saw three on the driver side there may be more. I don't know.
I double checked the wiring polarity at the fog light connectors and those are correct per the install video from Headlight Revolution.
I verified that the battery voltage is maintaining a steady 14.5V at idle.
I'm not sure what else to check.
Has anybody else experienced anything similar?
Any advice as to how I should troubleshoot this?
Thanks in advance for your help!
Last edited: