Bull rings

[GeoZ]

Any tried installing these bull rings?

 

[Jared B]

I put them on my old truck, easy 10 minute install if that. I haven't tried installing them on a 2019 yet though.

 

[GeoZ]

Does it need any drilling?

 

[Jared B]

Does it need any drilling?

No they just drop into the stake pockets and are held by the metal backing plate after tightening the screw down.

 

[GeoZ]

Thanks. How about the front of the bed? There are two plastic caps. Do I need to cut those out?

 

[Jus Cruisin]

Thanks. How about the front of the bed? There are two plastic caps. Do I need to cut those out?

The covers should be just clipped in. You should be able to take a plastic knife and pry under the sides to release them. PLASTIC knife..... So you don't booger up the bed rail.

 

[Twoamen]

I found they made holes smaller. The ones I had on 2014 RAM are to big, won't fit into hole to grab metal bed. There is also a formed pocket that sets below the metal portion of the bed pocket. If you find smaller ones to fit and screw tight the adapter plate it will only catch the formed plastic pocket compressing it. May become lose from use

 

[Slonis]

The gen4 and the gen5 habe the Same size and Bull Rings?

 

[Jedi9]

I put some in my truck but don't recall the brand and I can't find where I bought them. they work well, I remember I had to do some cutting inside the plastic pocket

 

[Ramnight17]

I have them on my 17, but I had to cut the bottom part a little of the side protector the pocket hole.