Wasachevyguy
Active Member
- Joined
- Mar 3, 2020
- Messages
- 47
- Reaction score
- 2
- Points
- 8
- Age
- 50
I realize there is a 32 page thread on leveling and Bilsteins, but its gone different directions and I’m hoping someone will take pity and help me figure out my specific problem. I just had the 5100 fronts installed on #6, along with the new UCAs (mine has 60k and figured cheap insurance) and an alignment. When I pulled in to pick it up I about had a heart attack. It looks like it has hydraulics on it it’s so unlevel. The rear is sitting at about 23 1/2” center hub to bottom of fender. On the front, I measured center of hub to the bottom of front fender and it is 25+”... up from ~22”. unless I’m misremembering what my front measured, how did I gain 3+” from #6? I’m at a loss.