biohazard
Member
- Joined
- Jun 15, 2022
- Messages
- 9
- Reaction score
- 5
Those would be XZN triple squares. Yet another fastener head option.
5thGenRams Forums
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Anyone know what kind of bolt this is
- Thread starter Code2medic
- Start date
Darksteel165
Legendary member
Never knew what they were called, but I got a bunch of them in various bit sets. No etorx though.
found this on the Ram-TRX forum from Viperjim
”And be extra careful with the rear bolts as the nut pockets are floating if you cross thread one , take your time trying to get it out as it is a square piece of steel that rides in 2 channels. If the corners of that pice get rounded you will have to try and pry something under the seat rail to put pressure on it to remove the bolt. There is no access holes under the underbody seat rail to try and replace that and then you’ll have to use your brain to try and figure out how to tighten it or loosen it. SO AGAIN BE VERY CAREFUL ON THREADING IT AND DONT USE AN IMPACT!!!! Use a racket and socket and go slow as to not jerk the nut pocket as it may bypass the corners of that piece of steel.”
”And be extra careful with the rear bolts as the nut pockets are floating if you cross thread one , take your time trying to get it out as it is a square piece of steel that rides in 2 channels. If the corners of that pice get rounded you will have to try and pry something under the seat rail to put pressure on it to remove the bolt. There is no access holes under the underbody seat rail to try and replace that and then you’ll have to use your brain to try and figure out how to tighten it or loosen it. SO AGAIN BE VERY CAREFUL ON THREADING IT AND DONT USE AN IMPACT!!!! Use a racket and socket and go slow as to not jerk the nut pocket as it may bypass the corners of that piece of steel.”
