To be honest. I’m not sure how possible it is to return to stock. To install the 6” the stock front cross member brackets had to be cut off.
From the install instructions
35. On the front side of the driver rear crossmember mount, measure 1” from the cam tab and mark. See Photo 31.
36. Using a reciprocating saw, cut the crossmember mount off using the mark made in step 35. Sand and paint cut edg-
es to prevent rust.
37. On the front side of the driver rear crossmember mount, measure down 1.5” from the cam bolt hole and cut the in-
side corner off. Sand and paint cut edges to prevent rust. See Photo 32. PHOTO 31
1.5”
PHOTO 32
38. On the front side of the pass rear crossmember mount, measure down 1.5” from the cam bolt hole and mark. Also, mark a line straight down from the inner cam tab, creating a triangle. See Photo 33.
39. Using a cutoff wheel, cut along the marks made in step 38. This is done for clearance of the supplied rear cross- member. Check the clearance by placing the supplied rear crossmember in the factory control arm pockets. Sand and paint cut edges to prevent rust See Photos 34 & 35.
PHOTO 33 PHOTO 34
1.5”
40. Install the supplied driver rear diff bracket using the factory hardware. Torque to factory specs using an 18mm sock- et. See Photo 36.
PHOTO 35 PHOTO 36
Sent from my iPhone using Tapatalk