Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
This info ONLY pertains to the Alpine stereo.
Went to replace speakers today, and when we pulled out the rear 6x9, it tested on a meter as 3.6 ohms. There is a lot of misinformation floating around apparently. Here's the speaker part numbers for 19 & 20.
2019 & 2020 amps - 68441768AA noise...
So what's the factory offset? The picture seems maybe a half inch or so too much for me. I want them right even with the fender flares, not sticking out.
So what's your point? You can run lower psi temporarily, but do you think that's good on your tires to do so? People put their tires all over the place, but that doesn't mean it's good on them. Proper psi is determined by weight of the vehicle, and load in the bed or on the ball. Not by how...
It's amazing some of the terrible advice I have read on this thread.
If you don't get flats in Goodyear SR-As, then you aren't going off road, or your gravel is extremely dull.
If you're running 10 ply tires under 40 psi on these trucks, you are affecting the long term integrity of the...
Anyone have an extra Infinity Kappa 32.9cf by chance? I have two, but not the third for center speaker. Or any 3.5 inch that are 2 ohm? Or a JL Audio C2-350x? Other type of Infinity? Thanks.
I had JBL in my 16 Ram, but wanted to see what other options were out there. My JBL crackled at high volume with Apline stereo. Would prefer better quality.
Only interested in 2 ohm. Those of you who have 4 ohm, are in fact losing volume. Go back to original if you don't believe me.
1 - while on a phone call on Bluetooth, out of nowhere the microphone stops working. I disconnect and reconnect Bluetooth and it works fine again. Acts like it's timing out the microphone.
2 - navigation is showing closed down businesses. Android Auto has very limited nav functionality.
3 -...
I wound up readjusting the bracket at an angle toward the driver side as far as it would go and adjusted the hoses. It fits, but barely. The can is hard to get to, but the valve is accessible. I won't be able to take the can off without removing the box first. I drained the can when I was doing...
So I got the spacers, just trying to figure out if I need anything else at this point. Summer saying that I would need new control arms, some are not. What about a differential drop kit?
I got it done. I just stripped a small portion of the I line wire without removing it, wrapped the wires, and electrical taped em. Mounted the lights on the top of the bumper. Will get pics later. Thanks everyone.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.