Search results

Good to know, thanks!

I have the Hellwig sway bar and am curious if the end links are mandatory? I'm sure they help, but does the MOPAR 2" lift require new end links?

Spot on, the pop noise with Carven is awful.

Magnaflow cat-back all the way.

Hello, After installing the Magnaflow cat-back system I noticed the flange was installed somewhat offset. Is this normal or should I disassemble and reinstall?

Thanks! Makes sense I don't have that piece with a non-lifted truck.

What's the silver bracket to the left? I have the Hellwig bar, but not that bracket. Curious to know.

Mine did not.

Reused the stock bolts and mine appeared to be all good (torqued down to 30 ft lbs). Also, be sure the hump on the bar isn’t faced up. See pic below for correct orientation.

Thanks for the heads up! Didn't have gloves, so i grabbed a sandwich bag and placed my finger inside that to protect from getting gunked up. That lube is a mess!

Applied lube inside the bushings and re-torqued to 30 ft. lbs. I should be good to go! Also, if you don’t have gloves around, grab a plastic sandwich bag, put your hands and finger inside and apply lubricant to inner bushings. Great way to get the job done and avoid the mess.

So, no lube between the “U” clamps that bolt to the “D” shaped to poly bushings?

Guess I'll unbolt tomorrow and apply the lube!

May I ask why?

Installed mine today and have a question I don't believe has been covered yet. With the polyurethane bushings, should I have lubed the inside of the "D" pieces before fitting them on the bar? I didn't apply the lube that was supplied because they went on so easily. Now I'm thinking the bushings...

Magnaflow catback and a Hellwig rear sway bar (check part number to account for lift) would be my first two adds.

I'm at 11k and just noticed this as well, has there been any dealer help for you? @RamCares What can you do to assist? This is terrible and unacceptable for $62k!

Curious about the same.

Just bought the black bezel to replace the chrome factory one, any tips on removing the stock one? Guessing the stock one will take some force to pry up and the clips will break off. Did the new one come with clips?

Tried to pop off with no success, any pro tips?