Remote Mount Oil Filter

[1BADRAMLIMITED]

Was thinking about going with this engine adaptor and the pac brake filter adaptor and have new lines made up to mate the two. I like this design a little better from looking at it. Moroso 23686 Moroso Remote Filter Adapters | Summit Racing

WHAT KIND OF LINES DO YOU USE FOR THIS PTFE? AND ALL A.N. FITTINGS?

 

[CHeYeNNe71]

We do not have a seal kit but you can order them individually

The O-rings are Fluorosilicone

HP1972 Small O ring

HP1973 Large O ring

I asked because I have one, yet to install and wasn't sure what seals they had or version. I might buy the new, just in case.

 

[RHO]

I'm not quite yet due for my first oil change, but I've been under the truck and read enough horror stories that I'm preparing my self with a Fumoto (or similar) drain valve, and I would like to investigate the potential use of an oil filter relocation system... Anyone used one on the 2019 5.7L and have any recommendations?

get some break clean to spray down the areas the oil gets on from the filter,

 

[Sarzoo]

I did my 1st oil change a couple weeks ago.

 

[Nascar Tommy]

Found the PacBrake HP10596 kit on sale for $242 at CspRacing with code "Xmas" ...

They show 2 more in stock for anyone looking. (mine shows it shipped 36hrs later ... ie today).

It seems to be out of stock at the PacBrake recommended sites, and I came across one eBay seller that mentioned both part # kits in the listing before finally getting confirmation it was the older superceded kit # xxx363. Along with this reply after some proding ...

... " The HP10596 has Fluorosilicone o-ring material for the adapter seals, whereas the HP10363 (now discontinued and superseded by the HP10596) had BUNA o-rings. "

---------------

Also ordered the Fumoto valve, F106SX
(with tube kit)


For reference later...

@Carlos.33193 posted the following oRings earlier at post 258 as replacements for the earlier PacBrake HP105363 kit but I wanted to have them added to my post to find them again later if needed for the the HP10596 kit.

And
Oil pressure/Temp before kit

- Cold startup

- Warm idle

- Warm running/driving

.

Love the speedo cover up!

 

[Mpgrimm2]

Ah keen eye you have. Yeah I'm not documenting that!

Sent from my SM-S926U using Tapatalk