Blind spot alert unavailable

[Scheiterlein64]

Dealership says the tail light is leaking which allowed water into the plug and corroded everything. Also ruined the blind spot module as well due to the moisture. Of course my extended warranty doesn't cover corrosion. So they have to replace the pigtail and the light. Hopefully this fixes the issue permanently.

 

[drew7811]

Dealership says the tail light is leaking which allowed water into the plug and corroded everything. Also ruined the blind spot module as well due to the moisture. Of course my extended warranty doesn't cover corrosion. So they have to replace the pigtail and the light. Hopefully this fixes the issue permanently.

Any luck on a fix? I took my light assembly off this morning and inspected both. There is zero sign of water/moisture damage and the harnesses look new. I cleaned them up and put some dielectric grease on the BSM module as well as the harness for the light assembly. The lights all work fine, it's just the BSM that keeps kicking the error on the dash (blind spot monitoring unavailable). What is the consensus on how to remedy this annoying thing? Thanks.

 

[josh_4184]

Hey guys similar issue, I was told you can turn off bypass the BSM if needed as I am waiting for new tail lights due to moisture tripping my BSM made my whole truck go heywire. Does anyone know whcih of these conenctors I need to unplug to turn off the BMS?

I beliebve it may be one fo the lower connectors on the block just not sure which one I have a 2019 Ram

 

[ejtorres]

Any luck on a fix? I took my light assembly off this morning and inspected both. There is zero sign of water/moisture damage and the harnesses look new. I cleaned them up and put some dielectric grease on the BSM module as well as the harness for the light assembly. The lights all work fine, it's just the BSM that keeps kicking the error on the dash (blind spot monitoring unavailable). What is the consensus on how to remedy this annoying thing? Thanks.

Were you able to fix it?

 

[2019-Ram-Limited]

Hey y’all! I just joined up as I too just started having this message displayed (Blind Spot Monitoring Unavailable. Service Required”) on the main cluster display. It shuts down the LKA on startup and I have to manually reactivate it.

From reading all the comments; I will remove both rear taillight assemblies & check/clean all connections.

However, before I do this; does anyone think it might be my right (passenger side) mirror that is causing this? I was backing into a parallel parking spot one day and I didn’t realize a telephone pole was extremely close to the curb. My mirror caught the pole as I was backing into the final position and the impact ripped off a piece of the lens cover over the outer turn signal. So now the LED array for the mirror’s turn signal is partially exposed to the elements.

Thanks in advance for any assistance!

 

[Handycraftman]

Here's my story. I also noticed a few more wires that are stressed.

Решение Blind Spot Monitoring Not Available

Был сильный дождь, когда BSM вышла из чата, оставив сообщение на панели приборов. На левом датчике отсутствовало питание. После прозвонки разьемов было обнаружено отсутствие линка на контакте 20 разье…

www.drive2.ru