Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
The replacements are rock solid. I tested them in the Mohave Desert the weekend that I installed them, world record temperatures... 130 degrees plus and never gave me a single problem. My original lights started acting up when temperatures were around 90 degrees. All seems well! Sure is a relief...
Known problem, they’ll send you a harness to correct the issue. I had the same problem, haven’t had one issue since installing the new harness.
Sent from my iPhone using Tapatalk
I’m sure they have, I bought mine on pre-order and worked with them on the solution. Morimoto sent me a resistor harness to solder in and I haven’t had problems since so I’m assuming they incorporated that into assemblies that have since shipped.
Sent from my iPhone using Tapatalk
I’ll keep the front wheel(s) in the cab if I need the security... otherwise I’ll put them in the bed as well. the mounts themselves are bolted to a track (which is hard mounted to the bed) so I can slide the mounts around if I need extra room.
Sent from my iPhone using Tapatalk
Installed some ditch lights... actually being used as forward spot beams. I'm a stickler for clean installs/wiring, I didn't want the hassle of going through the firewall so the wireless controller proved it's worth.
- Diode Dynamics SS3 Pro (spot) -- Jeremy at Retroshop.us
- Speedtech Lights...
Did you use the Speedtech to control a relay or send power to the light bar itself? I'm using it for ditch lights, totaling 72 watts which is roughly 6 amps. Technically, the Speedtech is rated to handle 10 amps per channel. I'm trying to decide whether to wire in a relay or use the control box...
Did you use the Speedtech to control a relay or send power to the light bar itself? I'm using it for ditch lights, totaling 72 watts which is roughly 6 amps. Technically, the Speedtech is rated to handle 10 amps per channel.
Morimoto's had to do with the heat inside the engine compartment... they have since sent out replacement harnesses that have solved my issue with them.
First post y'all. Looking to buy an exhaust for my Big Horn, set on Flowmaster's American Thunder series P/N 817843... Given the times, are there any smaller shops or dealers that can get me one? I'd like to support smaller businesses, if possible. I'm located in southern California (93041)...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.