Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I recently replaced my battery in my 2019 Ram 1500. My sunshade for my sunroof was open when my battery died. Once I replaced the battery my sunroof would not open or close, nor would the sunshade. If anyone has this issue, hold the sunroof close button (not the sunshade button) for 10 seconds...
I purchased a Taser DT second hand. I have purchased a code for the unmarry service and I have successfully married the device to my 2019 Ram 1500 Longhorn. I have also updated the firmware to the latest edition.
I changed the settings to be able to view my front, rear, surround cameras while...
No do not curt the black plastic harness. Buy a male bullet connector for Home Depot or Lowe’s and attach it to the white reverse wire on the light bar itself. Then plug the bullet connector into the black plastic harness. (Once you plug in the 4 pin harness from the light bar to the 5 pin curt...
The spacers I used, I got from Home Depot on the hardware aisle along with the bolts. I took the metal clips that came with the light bar to Home Depot and found the bolts and spacers that fit them. You need 1/4” spacer added to the ends of the light bar to clear the humps on the plastic of the...
Yes that is the wire harness for the backup camera and tailgate latch. I removed my tailgate for the install and I had to remove that plate with the tailgate. I used 1/4” plastic spacers on the ends of the light bar to clear the plastic bumps on truck. Then used 1/2” plastic spacer to clear the...
I used the curt 5 pin trailer harness to connect the wires from the light bar. For reverse wire (white wire) from the light bar I used a bullet connector and connected it to the 5th pin on the curt adapter. This way it is a true plug and play connection. No splicing or messing with factory...
I used the curt 5 pin trailer harness to connect the wires from the light bar. For reverse wire (white wire) from the light bar I used a bullet connector and connected it to the 5th pin on the curt adapter. This way it is a true plug and play connection. No splicing or messing with factory...
There are 4 on the rails and 2 inside the bed. I installed all 6. Used a router to cut through the plastic for the 4 on the rails. The 2 inside the bed are already cut out from the factory.
Thank you. I went with the AP4-CH41 incase later on I wanted to add additional amplifiers for my doors and dash speakers. If I’m not mistaken I think the APSUB-CH41 comes with outputs for subwoofers only. Overall I was satisfied with the fox acoustics box. The seat spacers do take up a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.