Recent content by Kevin C

Just bought a new 2022 Rebel G/T w eTorque. Completely stock, I'm averaging about 15mpg in mostly in town driving. I had been driving a 2019 Laramie with the 3.5" RediLift and 35" tires and was averaging about 15mpg. I figured the mileage in the new truck would be a few mpg's better before I...

Well, I installed the MX4 today and the BUG rails were not an issue at all. No idea why BakFlip thinks it won't work.

I'm assuming it may be a little different with the Rambox, but good to hear you didn't have any issues. Like I said in my original post, it seems as though there would be plenty of space. I'm hoping the retailer was just wrong. Thanks again.

For those of you who have the Bed Utility Group and installed a tonneau cover, did you have to remove the rails first? I just ordered a Bakflip MX4, and they told me that the BUG rails would have to be removed before installing the tonneau cover. When I watch the installation videos, it seems...

No, they are only 295/60r20's. They measure approx 34"x11.5". And I chose the +0 offset.

At some angles it can look slightly taller in front, but it is actually about 1/2" taller in the rear.

I've had my 3.5" ReadyLift installed for several months and have had zero rattles. Good luck in finding it, as that would drive me nuts.

I have the ReadyLift 3.5" lift w/ Nitto Ridge Grapplers (295/60R20) on 20x9 Fuel Offroad Mavericks with a 0 offset (stock is around +19). They are pretty flush - I actually wish they stuck out a little more. Note: I have a Laramie with the stock fender flares.

Well, I was driving by and pulled over for a closer look.

Nicely done! Looking forward to hearing the road test review.

From what I could see, there seemed to be new upper AND lower arms. But I really didn't spend much time there to figure it out. Maybe if it is still there next time I'm in that area, I will try to get some more pics of underneath. I don't think the lift was ONLY from the spacer, but the...

I was driving by a local dealer today, and had to pull over. They have this 2019 with a 6" lift and 35's on the lot (adding $12K+ to the price with their add-on extras - typical dealer overreach). When I looked underneath, it appears that most of the lift is achieved from what might be a 4"...

Looking forward to seeing it complete - and learn what you had to do to make it work.

Very nice. Like the red, white and blue RAM up front too! Nice touch.

I was just about to install the Rough Country 3.5" lift when someone posted the video below. Not sure if it is completely accurate - it's possible the RC would have been just fine - but I decided to go with the ReadyLift 3.5 instead.