Recent content by John Hable

Yes it was road salt.

On the Limited you recline the seat and then fold down the center console and reach behind the seat back you will feel where the seat is attached to the back wall of the cab there is a cord that hangs down. Pull on that cord and the seat back will fold forward on that side.

Your welcome

68276521AC, You will need to use some spray adhesive on the back to install it. That is why I didn't use it.

Jan 7, 2019 #70 GeoRam Here is my post from a few pages back. The seal will make a big difference. but to finish it you need to dynamat the rear cab panel. I have that posted a few pages back also I put the seal in last weekend and I think it...

I have had my Limited since the first of December and I have noticed when it is below freezing out my truck makes a loud humming noise at 2000 RPM going down the highway. It gets louder the longer you drive it at that speed and it seems to vibrate the floor under my left foot also. it takes...

68276521AC

I shined a flash light down the hole the seat belt is in and there is a divider between the seat belt pocket and the vent in the door jam with spray foam.

Bonebro, I had time this weekend to work on the sound detener on the rear cab panel. My truck according to the vin was suppose to have a detener on the rear cab. I purchased the factory one from ram and I did not like it, it did not have an adhesive back on it so I purchased some Dynamat Xtreme...

All I could get from my dealer was the truck according to the build date didn't use the seal. In my opinion you could run without the seal if the vent where stronger and didn't open so easy.

I put the seal in last weekend and I think it made a difference. I don't here the outside as clear as I did before. I feel without the seal the vents in the first photo are pushed open by the air moving between the box and the cab, It seemed like something was open behind the back seat. I didn't...

The seal part number for the lower front of box is 68309888AA.

I looked under my truck and the holes are there for the clips to put the seal on. after my service appointment next week if nothing changes I will buy my own seal and install it my self, if it helps I will let you know if not I will be buying a box of towels. I really like the truck itself but...

I had my wife drive me around also and I thought the same thing. I haven't stuffed any towel's in yet but I thought that would help also. I did find Ram deleted a seal that ran across the bottom of the front of the box that closed the gap between the box and the cab just below those vents. all...