Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
My truck with the Hemi does the same thing. I like it in the mountains compared to older vehicles where you’d have a runaway going downhill with the cruise on.
I recently traded in my ‘03 Cummins 2500 with the 6 spd manual for a 1500. I loved the truck, but maintenance costs were going to start to get expensive. Rear main, clutch, injectors were all just around the corner. There is nothing cheap when it comes to diesel maintenance and repair. While I...
This isn’t going to answer your question, but I have HK in my BMW and Alpine in the Rebel, and they are very close in my humble opinion. I personally wouldn’t pay more for the HK. For what it’s worth.
Yeah, I think it would be tough to do bumpers with the curves. It can be worked with a heat gun pretty well but I wouldn’t try bumpers. I’m in Canada where everything is more expensive and I was quoted $895.00 for rockers and door bottoms.
I haven’t done mine yet, but I’m guessing it’s inevitable. I actually have just installed Xpel Armor. I was doing some paint protection film and stumbled across it on the website. Looks exactly like spray-in liner, but is basically a big sticker. If it holds up, it’ll be spectacular as it only...
I would guess it will only get worse. I had a tv that started out with a single line and it didn’t take long to get unwatchable. But an electronic genius I am not.
Here you go. As you can see, room for a lot of stuff. Too full to get pics of the mounting, but there’s a slot in either back corner. You attach a flat bar to a bolt near the rear of the seat, and then slide the bar through the slot and lock it down with a linch pin. About 10 minutes to install.
Here you go. As you can see, room for a lot of stuff. Too full to get pics of the mounting, but there’s a slot in either back corner. You attach a flat bar to a bolt near the rear of the seat, and then slide the bar through the slot and lock it down with a linch pin. About 10 minutes to install.
I just installed the Duha storage in my quad cab. Remove 2 bolts to attach a bar that holds the unit in place. Very good fit. I installed on top of factory rubber floor mats without any problems.
I just installed the Duha storage in my quad cab. Remove 2 bolts to attach a bar that holds the unit in place. Very good fit. I installed on top of factory rubber floor mats without any problems.
I’ve got roughly 800 miles on Rebel and it’s done this a few times. A week ago I took it in and they uploaded the 21-002-19 TSB. Happened again yesterday so that wasn’t the fix for mine. I can go back and forth between park and drive all day long and drive won’t engage. If I go to reverse and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.