Recent content by Dschmid37

Yes

I had the Maxtrac 2/4 lowering kit installed on Monday. I did use the 1-1/2" spacers and the truck measures an inch and a half lower on the fronts with the split ring on the 4th groove. The rear measures 3" lower and still has some rake to it. It might settle some after a few miles, we'll see...

I'm about to order the Maxtrac 2-4 lowering kit and not sure if I should order the coil spacer or not. I called Maxtrac this morning and they're still recommending it. I do have etorque, I don't haul a trailer but I do hang my wifes mobilty scooter and power lift off the hitch occasionally. I'm...

Go get PPF tomorrow!!! Wish I had done it.

They're going to PDR all that they can. Hood and tonneau cover will get replaced. They think a few dents will need fill and paint due to their size and location to feature lines.

I'll find out because I have to drive it like that until October, which is when the body shop can get me in. 40-50 dents and a $9,600 estimate.

Had some custom body work done by Mother nature a few weeks ago....:cry:

Some guys with the cab length boards have installed these and seem to be happy. I don't need them (6' 5" tall). 😁 https://www.amp-research.com/bedstep-2-side-bumper-step/2022/ram/1500

I'm happy with these. LugCap 21-23 mm

Great truck 5thgen.ram, but those pictures?!?! The quality is so nice, it looks like they came from the Ram brochure! Great job!

Loosen the striker bolts (#40 Torx), and slide them rearward a little. Spray latches with silicone lube spray.

2002!

We have a lot of tinted front windows in my area. I'm hoping the police just don't care, and hoping my handicap license plate will sway any decisions to pull me over for tint. 😆 Good luck with yours!

Got my front windows tinted to match the rears.

Uhhhhhh.....no. The thread was evolving and I was talking about the 1-3 gallons that seem to be inaccessible. The OP definitely has something odd happening.