ImEngineer
Active Member
- Joined
- Nov 22, 2022
- Messages
- 29
- Reaction score
- 18
- Points
- 3
- Age
- 28
1) Windshield tint: I'd like to install a very low tint (almost clear) to the inside of the windshield to help cut down on the UV rays getting inside. Does anyone know of any sources for a good pre-cut windshield tint film?
2) Does anyone know of any sources for a good pre-cut PPF for the sides of the truck? The previous owner installed the front PPF, but that still leaves me susceptible to the Colorado pinstripes.
- Side note: I'm aware of two cons/risks with this and am willing to install the tint anyways given these two risks. If there are others I'm not thinking of, please comment below. The two I know of are: 1) tint on the windshield may make the windshield less clear due to the waviness of the film and 2) Don't get the BCM wet; people have fried various electronics letting too much water run down the dash when installing this tint
2) Does anyone know of any sources for a good pre-cut PPF for the sides of the truck? The previous owner installed the front PPF, but that still leaves me susceptible to the Colorado pinstripes.
Last edited: