Where can I get this switch?

[dcar777]

I am putting my train horns in my new Ram but I want it to be as clean as possible this time. No holes drilled etc. I want the switch that fits this blank to control the horn valve but for the life of me, I can t find it anywhere on line. The Google box has failed me. Do you know where I can find a switch that will fit this blank?

 

[Moosefire66]

I cant see a pic...

Sent from my SM-G991U1 using Tapatalk

 

[Richard320]

I have no idea what switch you're looking for, but if you have the homelink buttons on the visor.....

Looking to add AUX switches? Using the homelink buttons to control Lightbars DIY HOW TO for under $20.

So I just added MicTuning C2 rocklights under my truck and I didn't want to drill a hole on a panel in the interior of the truck. So I purchased a eMylo DC 12V 1 Channel 433Mhz RF Wireless Relay Remote Control Momentary Light Switch Self-lock Transmitter with Receiver for Home Use Learn more...

5thgenrams.com

 

[dcar777]

I cant see a pic...

Sent from my SM-G991U1 using Tapatalk

I cant see a pic...

Sent from my SM-G991U1 using Tapatalk

Sorry. I tried to add it again. Let me know if you can see it now. Thank you.

 

[Jimp1]

What about a rocker switch.

 

[BostonBLS]

My guess is that’s the air ride switch for higher and lower height. I haven’t seen that set up yet with the trailer assist.

 

[Jimp1]

My bad I thought you wanted to put a switch there.

 

[Swicago]

You can't just buy the switch. You have to replace the entire switch panel module with one that has a switch in that place. The only switch I am aware of in that space is the air ride switch, which again is art of the module. You might be able to swap in the module and most likely your truck will ignore signals from the air ride switch. If that is the case, then maybe you can high jack the contacts for your train horn, but it would have to be decoupled so as not to cause interference to the module it is attached to.
Probably easier to see of you can open up your existing module and see if you can maybe add some capacitive contacts onto the blank.

 

[Klicht87]

My guess is that’s the air ride switch for higher and lower height. I haven’t seen that set up yet with the trailer assist.

You are correct. It is for Air ride. It's a little bit different button setup with the trailer steering vs the regular button panel.