CHeYeNNe71
Ram Guru
Damn, guess mine were being stubborn. Guess plier it is this weekendDid mine by hand. They screwed out but wasn't smooth. Had a weird clicking when being unscrewed.
Damn, guess mine were being stubborn. Guess plier it is this weekendDid mine by hand. They screwed out but wasn't smooth. Had a weird clicking when being unscrewed.
The Fibrenew guys are usually a bit closer than that on matching texture. But it’s still better than a cracked or gaping hole in the seat.
Which one?Tonneau bed cover.
Looking closer at the picture, I think I'm going to have to have him come back. Looks like the texture patch he put on in first picture isn't clocked properly to line up with what's on the seat.The Fibrenew guys are usually a bit closer than that on matching texture. But it’s still better than a cracked or gaping hole in the seat.
I had some badly chaffed vinyl on a boat once and he didn’t have an exact match to the texture, so he made one by imprinting the vinyl in a good area. It was pretty much a flawless fix when he was done and matching airbrushed color. Like anything, not all techs are created equal.
Maybe the sensor’s getting squished or covered upHad a tonneau cover installed today. Kind of a weird fit because of the silver rails but I still like it.
Drive home and about 20 minutes later the truck alarm starts going off. Go out, turn it off and relock it. Come back in the house and it goes off again. Go back out and unlock it but this time open and close the tailgate, just in case it was because of the install. So far so good.
Anyone else experience the alarm going off for no apparent reason?
That’s what I thought. Looks to be about 30 degrees off pattern.Looking closer at the picture, I think I'm going to have to have him come back. Looks like the texture patch he put on in first picture isn't clocked properly to line up with what's on the seat.
Sensors? Where?Maybe the sensor’s getting squished or covered up