5thGenRams Forums

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

Truck not returning to Normal mode from Aero mode

1Raider

Well-Known Member
Joined
Jun 9, 2018
Messages
287
Reaction score
207
Points
43
Age
54
Has anyone else with the 4 corner Air suspension noticed there truck not retuning to Normal mode after being in Aero? Mine was working fine at 1st but has started doing that. Is there a way to reset it or something?
 
Has anyone else with the 4 corner Air suspension noticed there truck not retuning to Normal mode after being in Aero? Mine was working fine at 1st but has started doing that. Is there a way to reset it or something?
Mine does this too. Haven't looked into finding out why yet.
 
Is your suspension set to normal?
I leave mine in aero for the most part, but if I toggle it to normal it will raise and lower as called for by computer.
 
I ran into this last year. IIRC, to fix it I disabled aero mode (using uconnect settings) with the suspension at"normal" height. Then re-enabled aero mode. It should work as expected after that. Pretty sure it got messed up by disabling and enabling aero mode while the suspension was at "aero" height.
 
I ran into this last year. IIRC, to fix it I disabled aero mode (using uconnect settings) with the suspension at"normal" height. Then re-enabled aero mode. It should work as expected after that. Pretty sure it got messed up by disabling and enabling aero mode while the suspension was at "aero" height.
Thanks, I’ll give that a try!
 
At what speed should Aero kick in?
Try reading the manual dufus!!

From Normal to Aero between 62mph - 66mph for twenty seconds
Or 66mph and above.

Goes back to Normal between 30 and 35 for twenty seconds
Or drops below 30mph

I'll test tomorrow!
 
Thanks mikuru82 i'll try it tomorrow and see if it helps..

 
Try reading the manual dufus!!

From Normal to Aero between 62mph - 66mph for twenty seconds
Or 66mph and above.

Goes back to Normal between 30 and 35 for twenty seconds
Or drops below 30mph

I'll test tomorrow!
It worked! Had to get to 70 for it to drop to Aero but it may have been activated at 67 but I was at seventy before I noticed it.

Went back to Normal when my speed dropped to the low 30‘s

Thanks ya’ll for figuring this out!!
 
Last edited:
Truck is back to not going into Normal mode after getting off the Hwy once again.
Not sure what the deal is as I've tried turning Arero mode off and back on with it in Normal mode again and didnt help....
Anyone else's rig doing the same?
 

Users who are viewing this thread

Back
Top