Tazer DT changes not saving. Help!

[Maverick6]

I successfully paired my tazer DT and changed some vehicle settings (tire size and TPMS pressure values) following the instructions including the full reboot and 2 power cycles. The changes are not saving. I’ve been through the entire process 4-5 times.

Here’s what I’ve done specifically:
- put truck in run with engine off
- navigate to the audio screen
- use left arrow and cruise control bottoms to navigate through and change the tire size and TPMS settings
- use left arrow and cc buttons to navigate to and select full reboot
- once reboot finishes and shuts off, I open and close door and wait for 1 min after screen goes completely dark
- turn vehicle to run (engine off) and back off. Then open/close door and wait 1 min after screen goes entirely dark.
- turn vehicle on. Setting changes not saved.

What am I doing wrong?

 

[HSKR R/T]

I successfully paired my tazer DT and changed some vehicle settings (tire size and TPMS pressure values) following the instructions including the full reboot and 2 power cycles. The changes are not saving. I’ve been through the entire process 4-5 times.

Here’s what I’ve done specifically:
- put truck in run with engine off
- navigate to the audio screen
- use left arrow and cruise control bottoms to navigate through and change the tire size and TPMS settings
- use left arrow and cc buttons to navigate to and select full reboot
- once reboot finishes and shuts off, I open and close door and wait for 1 min after screen goes completely dark
- turn vehicle to run (engine off) and back off. Then open/close door and wait 1 min after screen goes entirely dark.
- turn vehicle on. Setting changes not saved.

What am I doing wrong?

For one, you are doing a lot of unnecessary steps with the opening/closing door, and going to run, then off. Cha ges should take right away. Every time aive made changes after the reboot I go right back into the settings and see they are changed. With the tire size changes take it for a drive to see if it took.

 

[Maverick6]

I was just following the instructions. Extra steps or not, the changes aren’t saving. Any other ideas why?

 

[cubb99]

I've seen a video where a guy activated the cruise control before making his changes and all seemed to work for him. I'm still considering buying one. Some people seem to love it and have no issues and others simply don't work and there doesn't seem to be much in between which i what im concerned about if im spending $330