Remove rear seat backs?

[MannymanX]

i have a "Dremel"will that be enough to cut it?

With the right tip, Dremel can definitely do the job!

 

[Walski]

Where did you ground the amps back there? I dont have the etorque but i have a bare bolt sticking up in the middle of that bubble tunnel of carpet where the etorque leads come out of yours. I was thinking this must be the factory ground for the etorque? Or is there a better ground under there somewhere?

I grounded to the same point as the etorque

 

[Luis1275]

Mine is a Bighorn w/ non-reclining seats. Not seeing or feeling a lanyard anywhere.

You need to unbolt. I have the same thing. Ram should made them all the same when it came the backseat.

 

[Luis1275]

He's talking about these. I trim back to the withe plastic/nylon part


View attachment 52083View attachment 52084

Question on this. So by trimming these down are you able to pull the back down as you pull the seat up??

 

[John Jensen]

Question on this. So by trimming these down are you able to pull the back down as you pull the seat up??

Yes

 

[ramButz]

Yes

hey john sorry it took so long to get back to you.but i finally started the "Back seat Mod".im using the "Dremell"its not to bad

 

[Bhenson54]

i have a "Dremel"will that be enough to cut it?

I'm in the process of removing my back seat out of my 2019 Tradesman Crew Cab due to the infamous water leak. Just a question.. when cutting these hooks it allows for the back of the seat to fold down. After this is done does the back stay up... say during hard braking ?

 

[ramButz]

I'm in the process of removing my back seat out of my 2019 Tradesman Crew Cab due to the infamous water leak. Just a question.. when cutting these hooks it allows for the back of the seat to fold down. After this is done does the back stay up... say during hard braking ?

yes

 

[John Jensen]

I'm in the process of removing my back seat out of my 2019 Tradesman Crew Cab due to the infamous water leak. Just a question.. when cutting these hooks it allows for the back of the seat to fold down. After this is done does the back stay up... say during hard braking ?

Yes, they still "lock up" normally. Trimming only changes the ability to fold them down. If you rim too much they will not lock up.

 

[Tattoofever6971]

How much do you trim ? I did a 1 1/2” still can’t pull down I cut off another 1/2” so about 2 “ total
Do some just not fold ?
I have. 20 quad cab ?