BlueHemi1500
Active Member
Hello all,
I have a 2020 Laramie with the 5-position (per the manual) Transfer case.
I have read the manual and tried to follow the directions step by step, I just can not get the transfer case into neutral.
I downloaded the manual and printed out the relevant 2 pages for towing flat as my truck did not come with a manual followed line by line without success.
I held the button for several seconds and no response.
Do you push with the pen on what looks like an LED at the top of the switch?
I can get the transfer case to switch to each of the other modes, 2WD, Auto WD, 4WD high, and 4WD low without problems.
I have googled my question and tried YouTube for a solution.
I have also tried looking on the forums where I am a member, but no luck.
There are no error codes and no check engine light on the dash.
So please help me figure out my problem.
I am sure the vast amount of knowledge here will provide me with the solution.
Thanks in advance all.
BlueHemi1500
I have a 2020 Laramie with the 5-position (per the manual) Transfer case.
I have read the manual and tried to follow the directions step by step, I just can not get the transfer case into neutral.
I downloaded the manual and printed out the relevant 2 pages for towing flat as my truck did not come with a manual followed line by line without success.
I held the button for several seconds and no response.
Do you push with the pen on what looks like an LED at the top of the switch?
I can get the transfer case to switch to each of the other modes, 2WD, Auto WD, 4WD high, and 4WD low without problems.
I have googled my question and tried YouTube for a solution.
I have also tried looking on the forums where I am a member, but no luck.
There are no error codes and no check engine light on the dash.
So please help me figure out my problem.
I am sure the vast amount of knowledge here will provide me with the solution.
Thanks in advance all.
BlueHemi1500