Hellwig Sway bar Help

[Repsol69]

I have a 2925 Rebel X and I'm trying to get some help cornering, It does sway around turns. Will an aftermarket sway bar help..??

 

[CHeYeNNe71]

Hellwig with Core4X4 solid rear links.

 

[Repsol69]

Hellwig with Core4X4 solid rear links.

Anyone running this set up


Sent from my iPhone using Tapatalk

 

[mplaramie]

I run the 7793 with Core 4x4 End Links, Upper/Lower Control Arms and Trackbar. Had the 7709 with Core 4x4 End Links on last Ram (23 Laramie) too. Nice set up.

 

[CHeYeNNe71]

Anyone running this set up


Sent from my iPhone using Tapatalk

Many, myself on my 4th Gen and will be soon on my 5th Gen

 

[bigdodge]

I have a 2925 Rebel X and I'm trying to get some help cornering, It does sway around turns. Will an aftermarket sway bar help..??

happy reading

Thread 'Hellwig? Hell, yeah!'

Aug 11, 2021

I just added the Hellwig rear sway bar. Thanks to everyone who recommended it (and the links to the AAFES store). I used the Hellwig heavy duty end-links.

I set the end-links to the middle hole in the sway bar. I've just driven about 20 minutes...and am amazed at the difference. What a phenomenal, and easy, upgrade.

Nits: The kit is a generic kit. I re-used my upper end-link bolt (had to, since there's a welded nut for it to thread into, metric, different than the SAE threaded hardware), and had to forego the inner washer. I figured the large flat mounting surface would suffice...

• c3k
• Replies: 595
• Forum: Suspension

• 

 

[Maverik259]

I’ve the the hellwig and core 4x4 street end links, and trail track bar. Went trail track bar because it was in their open box section. I’ll probably do the control arms next after my level kit.


Sent from my iPhone using Tapatalk

 

[CHeYeNNe71]

I’ve the the hellwig and core 4x4 street end links, and trail track bar. Went trail track bar because it was in their open box section. I’ll probably do the control arms next after my level kit.


Sent from my iPhone using Tapatalk

Yeah I have the Hellwig, Panhard and Control Arms from CORE4X4 to install soon.

 

[Phillykid]

2026 Bighorn Crew - Hellwig or Belltech make a great 1-3/8" solid front bar, Belltech substantively cheaper cost though. I have the Belltech front bar with a Hellwig 7709 (also solid) rear bar / Suspension Maxx front links and Core 4x4 rear links. Note whichever front bar you choose at least between these 2 I noted, will require minor mount hole drilling to fit the OEM-diameter 21mm end link bolts thru. I think the bar holes are 19mm. No issues with the rear bar mounting holes.

I also installed a Core 4x4 solid rear cross bar to replace the (also hollow) OEM part -

HUGE improvement over stock, hollow bars - no lean issues or feeling like you're pushing/pulling the truck into turns.