Sfalcon
Active Member
- Joined
- Aug 23, 2022
- Messages
- 31
- Reaction score
- 53
- Points
- 18
- Age
- 39
Hey guys.. picked up my truck at the end of October and ordered my Bilsteins right around then. They finally came last week, and I got my truck to the shop to have everything installed yesterday. Super happy with how it came out, thanks to everyone on this site and hours of me researching to figure out the perfect set up for me.
2022 Laramie night edition/6'4 bed/ORP/3.92/etorque
-Bilstein 5100 front and rear, front at setting #5
-zone ucas
-motofab 1" coil spacer in the rear
-bora wheel spacers 1" front, 1.25" rear
-Toyo open country AT3 35x11.5
Ended up gaining 2" in the front and 1" rear. Since I've got the ORP, this ends up at just about 3" total lift front and 2" total rear. I have about 3/4-1" of rake still. The one side shot of the truck looks like it's squatting, I had my old tires and some tools in the bed so it was sitting a little low. For anyone who's wondering, the Bora 1.25" and 1" fit great with the stock 20s with no stud trimming needed. The only tire rub I've got is some minor rub in reverse at full lock, nothing a little heat and massaging the wheel wells won't fix.
2022 Laramie night edition/6'4 bed/ORP/3.92/etorque
-Bilstein 5100 front and rear, front at setting #5
-zone ucas
-motofab 1" coil spacer in the rear
-bora wheel spacers 1" front, 1.25" rear
-Toyo open country AT3 35x11.5
Ended up gaining 2" in the front and 1" rear. Since I've got the ORP, this ends up at just about 3" total lift front and 2" total rear. I have about 3/4-1" of rake still. The one side shot of the truck looks like it's squatting, I had my old tires and some tools in the bed so it was sitting a little low. For anyone who's wondering, the Bora 1.25" and 1" fit great with the stock 20s with no stud trimming needed. The only tire rub I've got is some minor rub in reverse at full lock, nothing a little heat and massaging the wheel wells won't fix.