View attachment 168511
I like to party too.
I just picked this camper up this weekend, but I don't know what brand it is or any other info on it. I was looking for a model number also to get a key for it. I'm also looking for a good ideas of getting constant power for a switch panel for lights. Any help would be appreciated.
no idea regarding the cap but for switch panel, assuming for lighting inside the cap, you can do what I did:
Run a 8g power to the back with a 60A circuit breaker from Blue Sea Systems so you can switch it off.
I used a 50cal ammo can from Harbor Freight as housing for my power distribution box, inside I have Blue Sea Grounded Fuse Block and Blue Sea Bus Bar. I also cut the side of the ammo can and installed a 6 switch Nitelite switch there. I then managed to stuff a Renogy Solar Controller in there as well as a 12v ciggy plug too. I then drilled holes for mounting and for wires to pass through, then silicone it all. I mounted the box to my bed rail sitting on top of my Decked Drawer. Lights and stuff all went through that box.
For your case, you can skip the ammo can, just use a sheet of plywood and attach everything there since you don't need to worry about exposure to element. Just make the wiring clean following the same procedures.
see this post for bed lights at work
Quite productive this weekend. My Mountain Hatch Tailgate Insert was delivered on Tuesday and I put it on Friday. Within 30 seconds of installation my friends and I were enjoying our dinner on the newly install dinner table Then, I measured the distance between bed support and the outer shell...
5thgenrams.com
see this post for what I was talking about:
what mount is that? i might want to use that for my tablet to make operating it easier lol It's a Lido mount. (Click on the link.)
5thgenrams.com