firemedic10584
Ram Guru
So I opted to not install the small LED lights that come with the AMP steps. I've seen them in action and they're no impressive to say the least. So, I opted to install these instead - https://www.amazon.com/gp/product/B01JUE9OLM/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1
Cleaned the rocker panel real well then wiped it down with rubbing alcohol. Let it dry about 10 minutes then applied the LED strips. They come with the good 3M double sided tape so it's literally just peel and stick. Go slow and apply pressure as you go. I already had the AMP wire harness ran that had the light power wire. Soldered the connections together, tucked the wires up and zip tied them and was done. Took about 30 minutes from start to finish. They look great and light up the whole step in a bright white. Pictures below.
Cleaned the rocker panel real well then wiped it down with rubbing alcohol. Let it dry about 10 minutes then applied the LED strips. They come with the good 3M double sided tape so it's literally just peel and stick. Go slow and apply pressure as you go. I already had the AMP wire harness ran that had the light power wire. Soldered the connections together, tucked the wires up and zip tied them and was done. Took about 30 minutes from start to finish. They look great and light up the whole step in a bright white. Pictures below.