TruckDriver
Ram Guru
Long story short, my BLIS equipped tail light lens took a beating and originally just had a crack, now has a piece chipped out which I have in hand so it all still goes back together..
I have baked headlights and tail lights open in the past, preheating with an oven and then using a heat gun - I was surprised I haven't seen a single post on this forum yet so it looks like I'll be the guinea pig
Any chance someone has done this before on this specific taillight? I'm particularly worried about which clips I will encounter or any permanent bonding. Alternately, a molded cover that I can seal over the top would be ideal - I haven't seen one on the market, just vinyl overlays...
I have baked headlights and tail lights open in the past, preheating with an oven and then using a heat gun - I was surprised I haven't seen a single post on this forum yet so it looks like I'll be the guinea pig
Any chance someone has done this before on this specific taillight? I'm particularly worried about which clips I will encounter or any permanent bonding. Alternately, a molded cover that I can seal over the top would be ideal - I haven't seen one on the market, just vinyl overlays...