I struggled for a bit understanding it and still with communicating it…
So essentially, when you install the links you are essentially tricking the system to read “normal” as a higher setting… for me, I set the links at the or1 lengths. So my air system, because of the links settings, when enabled after installing, make the adjustment to the perceived “normal”, which is actually or1. On my switch, when I raise to or1, from the new “normal” it is actually raising to or2.
Based upon the switch to raise and lower, entry/exit is now old aero….aero is now old normal… normal is now old or1… and or1 is now old or2.
Did I lose or2?…. Only if you ask the toggle to raise and lower…. since or1 is now the new or2…
I hope this helps