6" Lift rear swaybar links BDS, Fabtech, RC, Procomp

[JerryBsizzle]

Trying to do a comparison. I have a 6" Fabtech lift and I have the ORP. My swaybar end links are 13" long center to center. Does anyone with a 6" lift know what theirs measure?

I'm very happy with it, and happy with the ride, I'm curious because the swaybar is tilted up significantly from stock. The ends of the swaybar on a stock truck run parallel with the frame. On my truck the tilt upwards by a couple of inches. See pic

 

[Abrams117]

I have a Zone 6 inch lift. My rear sway links are 16 inches long and the bar is parallel.

 

[JerryBsizzle]

Thanks sir! Thats what I was looking for. 3" difference between yours and mine, but I don't know what it means as far as driving and riding.

 

[Abrams117]

Kind of an odd thing, I wonder if the Fabtech kit coming with new rear control arms is why the sway bar links are shorter. The Zone kits just have brackets for the stock rear control arms.

 

[JerryBsizzle]

Yea I've wondered. I mean it rides good, may be just a bit tight. I'm just wondering what happens when I go with a Hellwig.

 

[SouthTexasRebel]

Yea I've wondered. I mean it rides good, may be just a bit tight. I'm just wondering what happens when I go with a Hellwig.

Did you test and figure it out? I was wondering the same thing about adding a Hellwig to a Ram with the Fabtech 6” kit, being I recently swapped kits from Zone to Fabtech and was thinking to add this mod.

 

[SKT Customs]

I have the BDS ones and they actually are aimed down a bit. Opposite of yours. Weird

 

[JerryBsizzle]

Did you test and figure it out? I was wondering the same thing about adding a Hellwig to a Ram with the Fabtech 6” kit, being I recently swapped kits from Zone to Fabtech and was thinking to add this mod.

Nope sure didn't get to test it. I'm in a Silverado now so sorry....