36 Degrees North Overland 1/2inch spacer

[36Degrees_North]

Finally had some time to install my 36 Degrees North Overland 1/2 inch front spacer. These are designed more for the snap ring adjustable front shocks so you can run less preload on the spring but still keep the lift height. I plan on running 5100s down the road but wanted to see how these would work on a stock strut assembly. Other then fighting a stuck upped ball joint install is relatively painless the aluminum plate just sandwiches between the top hat and the coil bucket. Before I had 37 inches from the ground to the center of the wheel well after I have a little over 37 and a half inches.

 

[Poundfoolish_ZA]

Hmmm interesting. just ordered a set of 5100s