Seperate topic ..are those amp steps on your quad cab? Im just curious where the bck bracket is and if you had to cut the board. Any pics with it open?
5thGenRams Forums
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
35” on stock 20’s
- Thread starter uclaure
- Start date
Jeffslonghorn
Member
- Joined
- Jun 27, 2019
- Messages
- 9
- Reaction score
- 1
Your lift look is exactly what I’m looking for. What size tires are you running? Do you have a front photo ?
Bcryan
Active Member
- Joined
- May 17, 2020
- Messages
- 126
- Reaction score
- 79
If you look there are a lot of tire WIDTHS posted on here. The width is usually causes the rubbing not the height in this case. Some trucks just sit a little higher/lower.. think of the weight difference of my crew cab 6’4 box vs a quad cab 6’4 or crew 5’7... not to mention options that ad weight
LNDRCKT
Active Member
I wish those were AMP steps. These are the Mopar steps for the quad cab. Did t need to shorten them. The AMP steps I had on my 15’ did need to be shortened. I would recommend them over the Mopar ones. They are so much faster than the OEM steps.
LNDRCKT
Active Member
Bufo
Active Member
- Joined
- Feb 17, 2019
- Messages
- 47
- Reaction score
- 80
I have those rims with a 285/65/20 tire. So about a 34.8” according to Nitto. I have a ReadyLift 3.5. No rubbing with the lift. I did run them for a day without the lift and they only really rubbed at full turn on a incline that I noticed. So some 5100’s would probably do the trick. They are just over 11 inches wide so that helps with the rubbing.
