2025 Limited w/HK stereo speaker upgrade

[Fastest H-Town Realtor]

So, decided to pursue the dash speaker upgrade. Bought speakers and harness adapters, only to find: The 2025MY is a 4 wire plug, not 2 wires, as all earlier models have. Well, damn. Don't know if I want to separate the 2nd set of wires and tie them into the harness or await the aftermarket to catch up with the new architecture.

 

[1791]

4 wires. so the tweeter and mid are on separate channels. somehow i don't think what you are doing will be a upgrade. that factory amp has alot going on. crossovers, time alignment and gain setting for the speakers they put in it. those factory speakers are a good match for the amp.
IMO change the amp and all speakers + subwoofer or change nothing. i would just leave it alone

 

[Supachargerstar]

So, decided to pursue the dash speaker upgrade. Bought speakers and harness adapters, only to find: The 2025MY is a 4 wire plug, not 2 wires, as all earlier models have. Well, damn. Don't know if I want to separate the 2nd set of wires and tie them into the harness or await the aftermarket to catch up with the new architecture.

Hey brother l, did you ever attempt to switch out the dash speakers? I'm tired of the muffled sounds as well?

 

[Fastest H-Town Realtor]

Hey brother l, did you ever attempt to switch out the dash speakers? I'm tired of the muffled sounds as well?

I put it on hold for the moment. The 25 HK dash speakers use a 4 wire feed for the 2 way speaker. All the speakers I've researched are 2 way but with a 2 wire feed. So, I either await a 4 wire feed speaker or separate the 4 wires on a 2 way speaker to feed the 4 wire Ram harness.

 

[tristainbdts]

maybe i am asking this on the wrong post but i have the Harmon system in my 2020 a couple months back i changed all 3 of the dash speakers, big improvement. yesterday i changed out the all 4 door woofers front 2 door tweeters to kicker's. not sure if it why but now i am getting a code in the amp saying the circuit is open for the door tweeters only. they seem to be working as they should but i didn't notice as much of a improvement as doing the dash speakers. i tried clearing the codes and they came back immediately and still haven't been able to get them to clear.

 

[RiffWrath]

I read where a guy was adding a resister to the new speakers because of the 2 to 4 ohms thing.