2 inch lift and level.

[Topher]

Hey guys looking for a 2 inch lift and level for my 2021 bighorn. I know zero about this topic. I know that I don't want Bob from bobs garage to install washers to get it done but I'm not looking to spend show truck money either. So what's a good price point for this and what would a shop typically install? New shocks? Spacers? Thanks for the help

 

[CRAIG4FSU]

I just had 2" Rough Countries installed in the front for $700 w/4 wheel alignment.

 

[WyoRam21]

Hey guys looking for a 2 inch lift and level for my 2021 bighorn. I know zero about this topic. I know that I don't want Bob from bobs garage to install washers to get it done but I'm not looking to spend show truck money either. So what's a good price point for this and what would a shop typically install? New shocks? Spacers? Thanks for the help

I did the Bilstein level on my 21 Big Horn. Set at 5 for 1.7” and put 295 60 20 tires on with no rub.

Sent from my iPhone using Tapatalk

 

[Topher]

I just had 2" Rough Countries installed in the front for $700 w/4 wheel alignment.

I like the price of the kit online around 350 not bad. I like that better than 50.00 spacers. Have you used their stuff before is it good quality?

 

[sep1006]

I had the Bilsteins installed on the front and set at 2". The Motofab 1.5" spacers installed on the back. Parts and labor was $640.

 

[Topher]

I had the Bilsteins installed on the front and set at 2". The Motofab 1.5" spacers installed on the back. Parts and labor was $640.

View attachment 97426View attachment 97427

Is there a benefit to doing shocks on the front and spacers on the back?

 

[sep1006]

Don't really know but I think it's cheaper than a lift and doesn't damage anything. I got that recommendation from here, there are many that have done the exact same set up.

 

[travler]

I just had 2" Rough Countries installed in the

I had the Bilsteins installed on the front and set at 2". The Motofab 1.5" spacers installed on the back. Parts and labor was $640.

View attachment 97426View attachment 97427

very nice, can you tell me how the control arm angle looks? I'm looking to do the same, but am concerned about the control arm angle being too high
front for $700 w/4 wheel alignment.

 

[CRAIG4FSU]

I like the price of the kit online around 350 not bad. I like that better than 50.00 spacers. Have you used their stuff before is it good quality?

My first time using them. I immediately noticed an improvement over stock. They have settled in the front like i was told they would by the installer and forum members on here. The shop that did them said they install a bunch of them and that the amount of customers coming back for warranty issue are no higher than their FOX and Bilstein installs.

 

[Topher]

I just had 2" Rough Countries installed in the front for $700 w/4 wheel alignment.

Did they do anything to the back or just installed the rough countries on the front?

 

[CRAIG4FSU]

Did they do anything to the back or just installed the rough countries on the front?

Just the RC on the front, but I liked the ride improvement so much on the front that they're doing FOX 0" for me in the rear. $500 installed.